How To Cut Out An Eaves Trough Folding Downspout

Step 1

Test fit the downspout elbow to the bottom of the downspout. The downspout elbow should be approximately 12 inches above grade level.

Step 2

Bend the free end of the elbow outward a bit, so that the downspout fits into the elbow rather than around the outside of the elbow. If you are working with plastic systems, the elbows are already designed this way. If you are working with aluminum downspouts, the elbow is crimped and can be easily bent outward and made large enough to fit around the outside of the downspout.

Step 3

Cut inward from the end of the elbow toward the elbow bend using tin snips. Make a cut 2 1/2 inches long. Make this same cut on both sides of the elbow, cutting a straight line that is along the center line of the elbow. At 2 1/2 inches in from the end of the elbow, cut upward over the top of the elbow. The result is that you will remove a section from the top of the elbow that is 2 1/2 inches long and as wide as the entire width of the elbow.

Step 4

Step 5

Set the 48-inch piece of downspout into the saddle created by removing the top of the elbow. Push the downspout so that it is inserted past the cut line and into the elbow not more than 1/2 inch.

Step 6

Drill a 1/8-inch hole on each side of the elbow, through both the elbow and the downspout. Fasten the two together with a single pop rivet on each side of the elbow. The pop rivets will act as a pivot hinge. With the top of the elbow removed, the 48-inch section of downspout will lift upward and out of the way when you need to mow the grass under the spout.